FREMO Minibox 2
Entwickelt von Pål Olson, und prinzipiell als reine Fahrzentrale konzipiert.
Die Minibox 2 kann auch für Stellwerke verwendet werden. Eine Pufferung (Tracking) von Schaltbefehlen erfolgt nicht - das müssen die anderen Komponenten selbst erledigen.
Fremo-Thread zur Minibox 2:
https://forum.fremo-net.eu/t/neue-fremo-treffenzentrale-minibox2/7310/7
Nachfolgendes gilt für Firmware Version 2.3 (erschienen ca. 2020):
The Minibox2 is normally just plug-n-play.
Power it up, and its Heartbeat/Status LED should light with a short blink every 2 sec indicating RUN-mode.
Plugging in a FRED should give activity on Loconet, thus blink the LN-LED.
The Minibox2 supports:
- RUN-mode (default at power up)
- IDLE-mode (short flash every 1 sec) - rail-sync on sending only DCC IDLE-packets, and
- STOP-mode (slowly blinking 1 sec on, 1 sec off) - rail-sync off.
If it’s blinking fast - then either it’s an error, or it is in boot-loader mode - which should not happen by accident…
Setting Minibox2 in different modes is done by e.g JMRI or any (Digitrax) throttle having the run/stop/idle button.
Anyway, the Minibox2 does always power up in RUN-mode.
Summarized features and spec:
- Plug-n-play - no configuration needed
- 120 slots (with smart DCC packet scheduler algorithm)
- Purge time intervall 120 secs
- Maintains F0-F20 state (regularly refreshed)
- F9-F20 supported by OPC_0xA3 and OPC_0xD4, and by OPC_IMM
- F21-F28 supported by OPC_0xD4 and OPC_IMM (not regularly refreshed)
- Two LN-B and one LN-T Loconet Connectors
- Supports Programming On Main (POM) - e.g global B4 setup
- Supports OPC_GPOFF, OPC_GPON, OPC_IDLE
- Supports OPC_IMM_PACKET
- Supports Decoder assisted Consist (Digitrax; advanced consist)
- Supports Accessory Decoder Commands - and sends to track
- Supports, and updates, Fast Clock slot
- Loconet Activity and Power On/Heart Beat LEDs
- Optionally On-board Galvanic Isolated Arduino USB-LocoBuffer
- Recommended Power Supply; 12-15VDC/1.2A
Stichwörter
- Anmelden, um Kommentare verfassen zu können